Best option is the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote # LC358590 that you referenced. This is the nicest auto leveling setup around but it will require you to remove your current trailer jacks. There is no way to convert your jacks to auto level so this is the only route. view full answer...
The Replacement Motor # LG-142178 that you referenced is what you need to replace the existing Atwood 75721 motor on your landing gear system. We have found that the higher-rated LG-196308 is not compatible with Atwood systems. view full answer...
There is a way to allow you to replace the factory cast equalizer on your 2003 Jayco Designer 31RLS 5th wheel trailer with the Dexter E-Z Flex Equalizers.
Since your current equalizers are just over 6-1/4" long you will need to use longer shackle straps to make up the difference as the # K71-654-00 only work with equalizers up to 6-1/4" long.
Since you mentioned your factory shackles are 2-3/8" long you can replace them with the 2-3/4" long # TRSL275 which will put you in the useable... view full answer...
There are different angled cones for the wheel lug nuts found on trailer wheels and hubs. The most common lug nut cone degree is the standard 60 degree like the part # 12CLN-L.
We also the 90 degree cone with part # STN569. view full answer...
Yes the Dexter E-Z Flex Suspension Kit # K71-657-00 definitely is a fit for your trailer based on the axle spacing and the shackle dimensions you listed. view full answer...
We do have a nice selection of switches that may work well to control the new LED light strips inside your cargo trailer. You will just need to make sure you choose a switch that is rated properly for the draw of your lights. Since LED lights aren't going to draw much power at all, going with a 10 amp switch like the Pollak Light-Duty Toggle Switch # PK34513 should be enough, but you will want to check to make sure.
This is a really nice toggle switch that includes mounting hardware and... view full answer...
I do have an option for you but we do not have a standard axle that would work on your 2010 Jayco Designer 5th wheel trailer. Instead, you would want to look into one of our Timbren Axle-Less Trailer Suspension Systems like part # TASR7KS01. This system will actually replace the leaf springs on your trailer with a set of aeon springs that will work to absorb road shock and support the trailer's load better than the traditional leaf springs would.
In order to add brakes you can use the... view full answer...
The Phoenix Faucets Hybrid RV Kitchen Faucet w/ Pull Out Spout, # PF231541 does not swivel but has a pull out spout. The Ultra Faucets RV Kitchen Faucet w/ Pull Out Spout - Single Lever Handle - Oil Rubbed Bronze, # 277-000190 will swivel as well as having a pull out spout. view full answer...
Due to how the Rampage Wireless Backup Camera # RA7710 charges (through a USB cable), you wouldn't be able to have it installed in a horse trailer or at the back of a camper and have it be charging. It can't be used while charging. view full answer...
To install the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 4-Point Set # LC358590 on your 2005 Jayco with an enclosed underbelly will basically just require you to open up the underbelly section where you'd install the rear jacks so that it can install and operate. Worst case scenario you are cutting access holes for the jacks to fit. view full answer...